Just a reference for me – this is specifically for this layout mounted above the pots.
MKI TONE BENDER OFF-BOARD WIRING PLAN
The final soldering of the board to the pots has not been done yet – that will be done when it is mounted on the actual enclosure lid, as opposed to the dodgy piece of cardboard that I’m using as a wiring template.
These little clips are handy for securing the reasonably heavy Belden shielded cable I’m using. It has its own ideas about how it would like to bend. I could probably warm it up and reshape it, but I don’t mind. It’s normally a two-core cable with shield, but I remove one core and use it for other purposes.
If you’re wondering, transistors: Q1, OC71. Q2, OC44. Q3 NEC ST303 (later removed and replaced with an OC71)
