Tools, Tones and Toys for Guitarists
Next up from Dylan159’s Unreleased Circuits is the Blendy Buffoon. We’ve had a bunch of different blend/mix/loop designs up already, but this idea was still missing. Some may have stumbled upon an issue where you couldn’t use a basic blend circuit with the likes of Marshall Bluesbreaker or MXR Dynacomp. That issue is due to … Read more
The Slow Gear emulates a guitarist riding the volume pot or a volume pedal, creating a swell effect. This will fit comfortably in a 1590B or 125B, though with the 1590B you’ll probably want to wire the pots off board or use long-leg right angle pots mounted on the component side. Here’s the schematic for reference.
Had a couple questions about stompbox use with line level, so I drew up this. This allows you to drop the line level signal down to instrument level, send it out to whichever stompboxes you want to use, then back and amplified back up to line level. Schematic and discussion here. Made two versions, one … Read more
Just stumbled across this on FSB. It’s a tap tempo + modulation add on for PT2399 delays designed by Electric Canary. It is digital so you’ll either need to buy a pre-programed chipset or burn the code onto the chips yourself. Lots of off board wiring with this, but it’s probably worth if you have … Read more
What’s the OCB you ask? It’s the bypass buffer circuit from the new version of Fulltone’s OCD. It allows you to switch between regular true bypass and buffered bypass. There are 2 versions: The first (smaller) inverts the phase of your audio signal when engaged (in bypass mode phase isn’t inverted). The second (larger) adds … Read more
Got a request for the DI portion of the Hartke LH1000 bass amp. This is more or less that, but with a simplified power section. In the amp this runs off a bipolar 15 volt supply, but I would think it would also work with regular 9 volt supply. There’s not an unbalanced output, but … Read more
This one was requested ages ago and I got halfway through laying it out, and then promptly forgot about it. It’s a power amp/speaker cabinet simulator, emulating a SLO power amp and a couple different speaker cabinets based on the value used for CX (see schematic for values). This layout follows the Rev4 schematic from the … Read more
Got a request for a dual buffer that inverted the phase of the signal. Found this post from Parasit Studio and used it for the basis of this design. I added polarity protection, power filter cap, and output caps. You can use either dedicated jacks for the in phase and inverted phase outputs, or use … Read more
The Incandenza Bypass is a simple, low parts count, relay-based true bypass circuit designed by Steve Demedash. It uses a normally open momentary SPST footswitch triggering a simple 555-based flip flop circuit, triggering a non-latching DPDT footswitch. The layout below reflects the pinout of the either the Takamisawa NA5W-K or Omron G6S-2 relays. These are … Read more
Here’s a nice utility box for home recording or even live application (if you’ve run into a sound guy who hates guitar amps 😠). It’s a direct box but also a cab sim (4×12). It won’t run off phantom power, so just power it with a 9v wall wart or a battery. Also, connected to … Read more