Tools, Tones and Toys for Guitarists
Another awesome contribution Chris Stelloh. Another 1980’s Boss pedal I use a lot, here’s the modified layout for the original gray NF-1 Noise Gate, courtesy of Guitar Electronics DIY PCBs in PolanD: SCHEMATIC I reversed the wiring for the decay pot, since it was working backwards from the original. The LM741 IC is being powered … Read more
Another great contribution by Chris Stelloh! This is a layout drawn from the Madbean Oracle project, which is, essentially the Boss CS-3 compression sustainer. I really like the sound of VCA-driven compressors, especially on sampled drum sounds. This Boss pedal has been around for about 40 years, and the Madbean version makes a few slight … Read more
Chris Stelloh have been playing around with Jürgen Haible Wasp CV Filter and sent me two verified layouts.. In hi sown words: I had a chance to build up that LM13700 version of the Wasp Filter and found that using a much different value of potentiometer for the cutoff control made for a better filter … Read more
Chris have done it again… “Gwion of Holy Island Audio builds awesome stuff and, included in the package if you purchased the debut release from Gwion’s band, Smothering, is a DIY PCB for a three oscillator drone synth called the Cannibal Pride. This is that synth, and it sounds KILLER – keep in mind that, … Read more
Heavily modified revebr unit by BJFe, treated by Chris Stelloh. A couple of the tweaks are from Björn – in particular, the 2k2 resistor from the source of Q1 to ground. Lowering that value fixes a volume drop that can happen when the 50k dwell pot is maxed. I replaced the second dwell pot … Read more
A little useful modulation daughterboard for your delay circuits. Created by the one and only Chris Stelloh. I originally made this for Ben Spinks, who verified it. It’s the modulation daughterboard for the 1776 Effects Multiplex delay and it works pretty well with just about any PT2399 delay circuit. I’ve listed my preferred values as … Read more
Here is a contribution from Chris Stelloh that seem to be really useful. Chris says: This is an updated version of the Demedash Incandenza micro-controller free clickless relay true bypass switch. It takes up a bit more room than a simple 3pdt, but because of the friction-free operation of the SPST button, it will last … Read more
Chris “SPIN Doctor” Stelloh did it again! Amazing work with this box of fairy dust and chaos. The layout is verified and good to go! …and here is a layout with “Stelloh mods“.
