Reverb
Sentinel
The Sentinel is a PT2399-based pitch modulator, delay, reverb and drone verb designed by Arnoud Philip (~arph) as part of the DIYSB 10th Anniversary design contest. It’s based on the Sewer Pipes ring-verb and the Noise Ensemble. Original thread here, schematic here. Should be able to squeeze it into a 1590B. Note: LED2 in the … Read more
DeadAstronaut Chasm Reverb
Been a while since I did a reverb layout and this DeadAstronaut design does not disappoint. It’s not a true-bypass effect, but uses some JFET switching so that tails are present when you turn the effect off. Coda Effects actually has a really good write up on the design. Ended up doing this one in … Read more
All-Star Reverb
Found this one over on FSB. It was designed by Induction and takes elements from the GGG D-Verb, BYOC 2-Knob, and CultureJam’s Box of Hall. Like those designs it uses a Belton BTDR-2 reverb brick, which can be mounted directly to the board from the solder-side. If you want a wetter sound, replace the marked … Read more
Valve Wizard Equinox II
Here’s a reverb circuit that doesn’t require a Belton brick–the Equinox II by Valve Wizard. It uses 2, PT2399 delay chips with a pretty standard input/output buffer built around a TL072. The original uses a J112 for switching the tails function, but I’ve simplified that with a just DPDT footswitch. Use one side of the … Read more
CultureJam Box of Hall
Here’s a great sounding reverb designed by CultureJam, built around the typical Belton BTDR-2 reverb brick. I’ve laid it out for onboard pots and the BTDR-2 being mounted from the solder-side of the board.
Madbean Ping (Reverb)
A great simple reverb from Madbean. You can find his 1590G size boards and infos on his website. The way the layout has been drawn you should be able to solder the brick directly to the board and lay it under it.
Wampler Faux Spring Reverb
The Faux Spring Reverb, like many pedal reverbs is based around a Belton reverb module. Originally it used the BTDR-1 (which is massive), but in this layout I’ve adapted it for the newer and smaller BTDR-2H. I’ve also simplified the power section a little, and used a TL071 for the second IC. In the original … Read more
BYOC Reverb 2
Got a request to make a layout for this schematic, and it turns out it’s the BYOC Reverb 2. You can use 9mm pots and board mount them from the component side if you like. There are a few jumpers, though one of them (the one by the lower IC) can be eliminated if you … Read more
Death by Audio Reverberation Machine
Here’s a cool dirty reverb effect by Death by Audio. It uses a Belton brick like many other designs, and offers clean reverb with the gain control turned all the way down. But when you increase the gain, fuzz is infused to the signal. You can mount the Belton brick to the board from the … Read more