vero-p2p
TONE BENDER ENCLOSURE: Finishing Enclosure, Yellow
Finally found a few vintage-style enclosures for some Tone Bender MKIII / MKIV circuits that I’ve built and had sitting around waiting for the right enclosure. Can’t wait to clean these up and get them up and running – currently wrapped in plastic and covered in oil, as they are raw steel after all. I’ll … Read more
D*A*M: Fuzzrong FR-70, 0.15″ Vero Layout
Unlike the D*A*M Fuzzrong FR-69, which is very much a straight germanium Fuzzrite, the D*A*M Fuzzrong FR-70 is a little different. It’s a version of the Rosac Nu-Fuzz, which was designed by Ed Sanner, the designer of the Fuzzrite. There are a some changes with component values, but you are basically looking at the bones … Read more
D*A*M: FUZZrong FR-69
This is the layout that D*A*M used for the Fuzzrong FZ-69, which is essentially a germanium Fuzzrite. I couldn’t make out the pot values or the 2n2 cap values on the photos I could find, so will have to take this at face value. D*A*M FUZZRONG FR-69 – VERO LAYOUT
D*A*M: Buzzotron, Schematic
D*A*M BUZZOTRON – EARLIER VERSION SCHEMATIC D*A*M BUZZOTRON – LATER VERSION SCHEMATIC 27k instead of 22k resistor to Balance pot and 33k instead of 10K resistor from 1n on the Attack control to ground (lowering the filter frequency)
MARSHALL: SupaFuzz, 0.15″ Vero Layout
This is the original 1968 0.15″ vero layout for the Marshall SupaFuzz (which may be disputed by some). The cuts may not be in the exact positions as the original, but no matter… same with Filter pin 3 connection. This may be on the other side of the board, but that makes no real … Read more
