Loundsberry Nigel Touch Overdrive
Schematic avaiable at FSB. Subbed the 6,8k Drain resistors for a couple of 50k trimpots for easier bias setup.
Unverified
TC Electronic Dark Matter Distortion
Per request. A few things changed compared to the schematic; Bass ctrl outer lugs swapped, the two parallel 220uf power filter caps changed to a single 470uF (but you will get away with a 220uf or 100uf…), series protection diode added and bypass mute switching is omitted. SCHEMATIC.
Dunwich Amplification Bass Overdrive (DIY)
Based on Boss ODB-3 but with lots of added controls and switches! Schematic and BOM at OSH Park.
Dunwich Amplification Apostle (DIY version)
Schematic and BOM avaiable at OSH Park. Looks like a very interesting Matamp/Orange amp emulator running mostly at almost 36v with an active speaker simulator(?) and a “Mode” switch for two tonestacks. Each being at different locations in the circuit.
Dunwich Amplification CTG (DIY version)
Here we have a “little” monster layout for a DIY project that Dunwich Amplification just released at OSH Park. It is supposed to a emulate a part Al Cisneros of Sleep bass rig. It is basically three circuits in parallell, a DOD 250 Pre Amp, a Boss DS1 and a clean J FET boost with … Read more
GuitarPCB Plexi Plus
This was a request. Based on Ramble FX Marvel Drive but with some tweaks. Schematic and info HERE
Seppuku Fx Memory Loss – alike
The layout is based on a quite diffucult-to-read schematic found at Mod Wiggler forum. It may contain some errors and there are few question marks next to some of the pots and one of the caps, so some “trial and error” might be necessary to get this thing working as it should. Also, the “Filter” … Read more
Death by Audio Super Fuzz War – Fuzz section
Deadend Fx just traced this rare beast and released a PCB for it. Go and get it! If not, here is a couple vero layouts for the fuzz section. I will upload the Boost section once I can wrap my head around some of the switch connections…. There are two layouts, one stock the with … Read more
Paul Cochrane Timmy V1
This one has been requested for a while. There seem to be several versions of this circuit so I guess we should start with V1? There is several schematics online, all of them have different wiring for the Bass and Treble controls. So the lug numbering may need some corrections.
